on 11-05-2008 5:13 AM
Hi Guru's,
I get the error mentioned below in detail when I try to broadcast a particular workbook.
Please suggest what is to be done to remove this error.
500 Connection timed out
-
Error: -5
Version: 7000
Component: ICM
Date/Time: Wed Nov 05 10:31:16 2008
Module: icxxthr.c
Line: 2698
Server: BI7PRD_BIP_00
Error Tag: {-}
Detail: Connection to partner timed out after 60s
Regards,
W. Archana
Hi,
The error says that the Connection has timed out, ie. the connection between BI and EP has timed out. You have to increase this time. It has been set as 60 s. Normally SAP would recommend to set this as 900 s.
You can do this by going to t.codes RZ10 and RZ11.
Hope this helps.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
In RZ10, you have to select the Profile Name (server name basically). After selecting the profile, select the option of Extended Maintenance and then click Display.
There is a table and there is a field "rdisp/gui_auto_logout", set this as 9000 going to the edit mode and "rdisp/max_wprun_time", set this as 90000.
Hope this helps.
hi,
After solving the problem....again the next error
Precalculation failed: E BExExcelPrecDLL.StartCalc: Connection was not pass
Cannot precalculate workbook NGN Balance Sheet
for the above error I found on SDN to refer not 924030.
But our setting are the same as mentioned in the note.
Please guide
regards,
Archana W
IT was BASIS problem solved by the BASIS consultant.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You are broadcasting this in background aren;t you via a scheduled job - and not execute immeediately?
If you arent doing it - then its the normal bex timeout - ie the query is taking too long to run - run it via trhe scheul - non periodic job - start time a minute after
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.