Skip to Content
avatar image
Former Member

How to test the adapter ?

Hi

When you create an adapter it would be inactive in adapter monitoring and it would be active only when atleast one message is passed through it ? how do we test the adapter is working fine or not ?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Oct 21, 2008 at 06:50 PM

    You can check your adapetes in RWB under component monitoring. you can use filter to select your adapter only.

    Regards,

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      HI Radhika

      As suggested by everyone here

      Go to RWB->Component monitoring->Adapter engine->Test message.

      Paste a payload anything just after the creation of adapter and test it. Give dummy values or any built scenario credentials on the same PI system you will get error at max thats it but it will activate the adapter.

      Thanks

      Gaurav

  • avatar image
    Former Member
    Oct 21, 2008 at 06:39 PM

    Hi,

    Access RWB -> component monitoring -> display all -> select you adapter engine

    Now below is click on "communication channel monitoring" and select the communication channel which you want to see. Then below you will see what your adapter is doing. If its fine or having errors

    Add comment
    10|10000 characters needed characters exceeded