on 10-21-2008 7:00 PM
Hi
When you create an adapter it would be inactive in adapter monitoring and it would be active only when atleast one message is passed through it ? how do we test the adapter is working fine or not ?
You can check your adapetes in RWB under component monitoring. you can use filter to select your adapter only.
Regards,
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Radhika
As suggested by everyone here
Go to RWB->Component monitoring->Adapter engine->Test message.
Paste a payload anything just after the creation of adapter and test it. Give dummy values or any built scenario credentials on the same PI system you will get error at max thats it but it will activate the adapter.
Thanks
Gaurav
Hi,
Access RWB -> component monitoring -> display all -> select you adapter engine
Now below is click on "communication channel monitoring" and select the communication channel which you want to see. Then below you will see what your adapter is doing. If its fine or having errors
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.