Skip to Content
avatar image
Former Member

Change Product id in SRM

Hi,

I have a requirement where when a product is loaded from R/3 to SRM (either initial load or delta), we have to check if the material in R/3 has a manufacturer part number and if it has then the product in SRM should be created with the manufacturer part number as the product id.

I have been trying to find any badi in SRM to support this change but could find any yet.

Could someone please suggest something on this?

Thanks & Regards

Saravanan Sadasivan.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Oct 21, 2008 at 10:25 AM

    Hi,

    While this is certainly not advised as there will very likely be some consequences of this, the only Badi(s) which may be of us in this scenario are PRODUCT_CUSTOMER and PRODUCT_CUSTOMER2, thereyou can make use of the method R3_TO_CRM_MATERIAL

    Regards,

    Jason

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Guys,

      How do I use the BADI PRODUCT_CUSTOMER2, method MAP_R3_TO_CRM_MATERIAL is there any sample code??

      I am trying to use this to change the material number of a material being replicated if the number already exist in SRM. I am integrating wioth multiple ECC systems, therefore the likelihood of replicating materials with IDs which already exist in SRM are high and the replication of those will not work.

      Is there a better solution to my problem other than this??

      regards'

      David