on 10-21-2008 8:14 AM
Hello,
I want to create an extractor ( 7.0 ), for loading hierarchy into an infoobject. I came to know that its not possible to create Hierarchial datasource
in 7.0 flow ( possible only in 3.X).
still is it possible to create one through RSA2 transaction?
In RSA2, if i create a new datasource, there is a field DataSource Type--> and the F4 help gives an option of HIER ( Hierarchy nodes )
is it the right way to create one??
Thanks
Karthik
Hi ,
using ras1old you can upload the Hierrarchy data (same procedure that you will follow in 3x).
rsa2 is not the procedure.
Regards
Ramakanth.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Karthik,
you need not create the data source in rsa1old, you can create the 3.x datasource for flatfile(Hierrachy load) in you BI 7.0 rsa1 transaction.
follow the same steps as you would in 3.x system.
1) hierarchy defined for the Infoobject
2) create the flat file datasource, with the field structure for Hierarchy load (node ID, infoject Name ....)
3) create the 3.x Infosource
hope this helps...
Regards,
Umesh
Have you tried transaction BW10 for creating datasource.
May be that may help.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Thanks for your reply.
The BW10 transaction does not seem to exist.
And i followed the steps mentioned in the link. In step 3, after entering the source system, i am getting a pop-up where i am asked to select
a datasource.
Here there are only two datasources present for selection
one is attribute datasource , other one is datasource for loading text. ( which were already there).
Here i am supposed to get another datasource name ( Hirearchial datasource ). I know that i have to create one before following the steps mentioned in the link.
( So that i get my hirearchail datasource name for selection in that pop up )
my question was how do i go about creating this datasource. In RSO2 transaction , i can create datasources for loading text, attributes and transactional data.
There is no option for creating Hirearchail datasource.
Isnt RSA2 for display of datasources ??
Anywayz for your hierarchy check the below link :
http://help.sap.com/saphelp_nw04s/helpdata/en/80/1a6729e07211d2acb80000e829fbfe/frameset.htm
Hope this helps.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Doubt not yet cleared
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.