Skip to Content

ChaRM - ZMMJ change configuration item

Hi

I need to change the configuration item on a ZMMJ document in ChaRM.

I have gone into SPRO and made this "Executable" for In Development status.

However, there is still an issue. If I create a ZMMJ without a change request (which we actually have turned off), I can change the configuration item in the status mentioned above. But if I go into a ZMMJ document that was generated via a Change Request (ZMCR) I CANNOT change the Configuration Item in the same status...even though it's executable in SPRO. Why is this?

Given we ONLY create ZMMJ documents via a ZMCR, this means we can never change the configuration item. Surely there is something I can so this can happen?

Anyone have any suggestions?

Thanks
Shaun

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Apr 27 at 12:02 PM

    Hello Shaun Kitching

    you can try below report

    AI_CRM_MODIFY_IBASE_IN_DOC in se38 and try to give cd no. and old and new IBASE.

    2447548 - Report for Replacing Ibase component in documents

    this should resolve.

    Thanks

    Prakhar

    Add comment
    10|10000 characters needed characters exceeded