Skip to Content
avatar image
Former Member

Smartform output

Hi all,

I have imported standard SAP SmartForm /smb40/sdorc_a and I am using it with standard SAP program /smb40/rvador01

but when i try to test it i get an error Output could not be issued

If anyone can provide me with any info on this one???

Thanks in advance,

Maja

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

7 Answers

  • avatar image
    Former Member
    Oct 18, 2008 at 04:35 AM

    first u have to set the 'Display - output' options has to be set for the standard transaction. Check whether it has been set or not?!

    Ask ur functional consultant to set in the standrd transaction.

    regards,

    padma

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 19, 2008 at 09:24 AM

    See,

    Standard smartforms are ment to be executed using some t.code. If you go to se38 and try to execute the program you wont get the output. The type of driver program is always 'S' (Subroutine pool).

    All you have to do is identify which tcode is using the driver and form.Goto Tcode NACE and check whether the configration is done properly or not. Once you are satis fied with the setting goto the tcode which uses the form Enter the nessasary data and see the output.

    Take the help of functionals for Nace configration and showing you the first out.If you are doing any changed in the form ot program you need to make sure thet the program will be called with some standard tcode and the configration is done properly.

    Thanks,

    sandeep.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 19, 2008 at 10:50 AM

    Hi Maja,

    You might have not configured NACE according to your subroutine-pool name and smartform name. Configure nace and try you will get it.

    Cheers!!

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 25, 2008 at 06:37 PM

    Hi Moja,

    Please configure your smart form and driver program in NACE transaction correspoinding to the output type.

    then automatically it will execute it properly.

    Thanks,

    Chidanand

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 01, 2008 at 09:20 AM

    Hi Maja,

    I think you dont ve to set the Nace Configuration, because it is a standard program but if you ve changed the Nace Configuration then you need to reconfigure it again.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 02, 2008 at 06:44 PM

    Hi,

    Are you using a Z output type? Then Only NACE comes into Picture.

    Check this Thread: Error in smartform

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 03, 2008 at 11:19 AM

    hi,

    the reason for this could be that either data for some window is not coming and u hav enot put a condition on window that if initial it shud not display..

    or because some where data is exceeding the size of window..

    u can check all this by using transacction smartform_trace..

    regards

    palak

    Add comment
    10|10000 characters needed characters exceeded