Application Development Discussions
Join the discussions or start your own on all things application development, including tools and APIs, programming models, and keeping your skills sharp.
cancel
Showing results for 
Search instead for 
Did you mean: 

Vendor Master Replication Error from ECC to SUS : Error in ALE Service

former_member526144
Active Contributor
0 Kudos

Dear Experts,

We are implementing MM SUS (SRM 5.0). As a part of this we need to replicate vendors from ECC to SUS system via XI. We have created a Reduced Message Type Z_CREMAS_SUSMM and had set up the partner profile in WE20 with SUS logical system as destination and specifing the Message Type, and port of the XI system

We executed the transaction BD14 for replication, it is resulting in error 29 : Error in ALE Service : Entry in Outbound table not found.

Please provide inputs to overcome this problem

Thank you,

Regards,

Ravi

1 ACCEPTED SOLUTION

Former Member
0 Kudos

Hi Ravi,

You might have done the ALE configuration correctly, but you might not have maintained the Partner Profile (WE20 transaction), you need to maintain the entry in the Logical System partner type for the message type in the Outbound interfaces in the sender system and in the same the partner profile has to be maintained as inbound interface in the receiver system, then only the transfer of data will happen.

Thanks,

Mahesh.

4 REPLIES 4

Former Member
0 Kudos

Hi,

Check

Looks like some issue with the partner profile set up for the sender or receiver of the EDI message in WE20.

Set up them again and When these have been set up try reprocessing your IDocs from BD87

Former Member
0 Kudos

Read the ALE primer again. You dont have the outbound partner profile maintained

Former Member
0 Kudos

Hi Ravi,

You might have done the ALE configuration correctly, but you might not have maintained the Partner Profile (WE20 transaction), you need to maintain the entry in the Logical System partner type for the message type in the Outbound interfaces in the sender system and in the same the partner profile has to be maintained as inbound interface in the receiver system, then only the transfer of data will happen.

Thanks,

Mahesh.

0 Kudos

Resolved myself. We have maintained partner role "LS" in partner profile settings as per sap config guide but we should not maintain this.

Thanks

Ravi