Skip to Content
avatar image
Former Member

Parameter Panel Screen Crystal 2008 SP1

I schedule a Crystal Report and then I open the instance. I can not change the parameters in the parameter panel. I believe we were able to do this in Crystal 2008 SP0.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Oct 20, 2008 at 07:01 PM

    Hello Brian,

    Are you able to change the value when you run the report in the designer?

    When creating the prompt, the value for Show on (Viewer) Panel needs to be set to Editable. If it is set to Read Only, you will not be able to change the values. Please check this value to make sure it is set for the report.

    Add comment
    10|10000 characters needed characters exceeded