Skip to Content
avatar image
Former Member

Portal screen shows three zero's after decimal

Hi friends,

We are implementing ESS MSS.( record working time)

In our portal sceen only for actual hours it displays 3 zero's after decimal.

Its only there for actual hours display row.

in R/3 it shows two zeros after decimal.

In portal it does not even allow to enter the 3 values after decimal.

Can any one provide solution

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Oct 15, 2008 at 02:23 PM

    You have to change the value to 2 for the DECAN field in Table T006 for the Measuring Unit Time (H).

    ~Suresh

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 15, 2008 at 02:37 PM

    You can change as SUresh Listed

    In the timesheet application, the Unit u2018Hu2019 (Hour) is used.

    Go to transaction CUNI.

    Select u2018Units of Measurementu2019 as Time.

    Click on u2018Units of Measurementu2019.

    Then change DECAN, to 2.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi,

      We want the hours entered in CAT2 screen as a whole number. Where can I change the settings to allow only whole numbers to be entered in CAT2?

      Thanks & Regards,

      Jegashree

      Edited by: Jegashree on Feb 8, 2011 1:25 PM

  • Feb 08, 2011 at 07:20 PM

    same place

    You can change as SUresh Listed

    In the timesheet application, the Unit u2018Hu2019 (Hour) is used.

    Go to transaction CUNI.

    Select u2018Units of Measurementu2019 as Time.

    Click on u2018Units of Measurementu2019.

    Then change DECAN, to 2.

    dont allow any decimals! You can change it here check it

    Add comment
    10|10000 characters needed characters exceeded