cancel
Showing results for 
Search instead for 
Did you mean: 

AFS SD Compleate delivery issue .

Former Member
0 Kudos

Dear All.

I have an issue in compleate delivery in maintenance afs ecc 6.0

I followed following steps.

1. customer master shipping tab

tick compleate delivery reqd by law.

partial delivery per item "c"

2.spro made following change .

spro_logistic execution_shipping_system modification_specify characteristic for system messages _define message type for system message , L VL 062 , earlier it was "i" i change it to "E"

3.Then I create sales order and create delivery with reference to that order.

eg . with this customer master selection , If the order qty is 100. create delivery for 75. then system should gives error message and stopp delivery creation.

4. My issue is after config change I to E .my delivery qtyget split. I couldnt understand why it happen.

5. My requirement is I need to deliver only compleate delivery. with above settings in customer master. if I try to create less qty which is mention in sales order system should pop up error message and stop delivery creation.

could you please help me . Tell me the way did is correct? please explane any other method . Explane the steps .

Thanks Regards

Accepted Solutions (0)

Answers (1)

Answers (1)

Former Member
0 Kudos

hello, friend.

remove the entry 'c' in partial deliveries per item. making entries here conflicts with your specifications in 'complete delivery required by law'.

you make entries here only if you allow partial deliveries at header level but restrict certain items to complete deliveries only (e.g. your order has 3 items, which can be separately delivered, but each item must be delivered completely; however, your order qty of 100 was still split).

try the above and please post feedback.

regards.

Former Member
0 Kudos

Hi thanks for you reply.

I have change the i customer master shipping tab. . you cant put only the tick it gives aerror message . "When complete delivery specified, no subsequent/partial delivery allowed" so I put only c for partial delivery allowed.

then I created sales order, Arun . delivery creation.

now the problem is system autometically generate 2 split deliverie . my order was qty20 withe 4 sizes. first delivery created qty 10. didnt get any message. I cant figure out why this is happening?

system should ideally give an error message and stop delivery creation. Do I need to make any config changes? If so tell me what need to be done. Is there any alternative way of doing this ?

could you please reply

Thanks Regards

Indika .

"

Former Member
0 Kudos

hello again.

in one of our projects with the same requirement, we merely ticked 'complete delivery required by law' in the CMR-shipping tab. we left all partial delivery fields blank. we also did not have to configure the messages as you did.

now when we make deliveries with reference to order, the system either creates the complete delivery or does not. i do recall a message pops up to advise about the complete delivery requirement.

please test again and post your observations.

regards.