on 10-10-2008 1:16 AM
Hello Experts,
I'm trying to execute query on the web from BEx Netweaver 2004s.
But I get this message:
The page you are looking for might have been removed or had its name changed.
And the wired thing is I don't get host and port number in the address bar.
But when I execute query from BEx 3.x it works.
What settings should I check and make so that it works fine in the new version.
One of the parameter icm/server_port_0 has a timeout limit set to 150.
Thanks in advance.
Thanks All of you but no luck as of now.
While manually adding host and port into the address bar i got this message:
The initial exception that caused the request to fail, was:
Connect from SAP gateway to RFC server failed
Connect_PM TYPE=A ASHOST=soanetp2:8001 SYSNR=01 GWHOST=soanetp2.GWSERV=sapgw01 PCS=1
LOCATION SAP-Gateway on host soanetp2 / sapgw01
ERROR hostname 'soanetp2:8001' unknown
TIME Fri Oct 10 15:52:43 2008
RELEASE 700
COMPONENT NI (network interface)
VERSION 38
RC -2
MODULE nixxhsl.cpp
LINE 223
DETAIL NiHsLGetNodeAddr: hostname cached as unknown
COUNTER 10
com.sap.mw.jco.JCO$Exception: (102) RFC_ERROR_COMMUNICATION: Connect from SAP gateway to RFC server failed
Connect_PM TYPE=A ASHOST=soanetp2:8001 SYSNR=01 GWHOST=soanetp2GWSERV=sapgw01 PCS=1
LOCATION SAP-Gateway on host soanetp2 / sapgw01
ERROR hostname 'soanetp2.us:8001' unknown
TIME Fri Oct 10 15:52:43 2008
RELEASE 700
[...]
While following SAP note 947148 I found that we don't have any entry in table RSPOR_T_PORTAL
What entry it should have? The note says that there should be a prefix maintained for your portal.
Hope to solve this problem this weekend and let you all know what all steps i took.
Thanks in advance
Sonu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
The URL is taken from the table RSPOR_T_PORTAL. Please check note 947148 which explains this issue.
Regards,
Janine
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Just a couple of sense-check questions:
Have you converted the query to 2004s?
Have you tried running the converted query in RSRT?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
I am facing the similar problem with you.
My situation is, i can execute and get the result on webpage in 3.x after replace the host name as IP in URL. But i get the similar URL in 7.0 as you listed above and i do not know how to figure it out.
The connection is OK after checking SM59 but i can not change the host name to IP address.
I think there should be some place to configure this scenario.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
83 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.