Skip to Content
avatar image
Former Member

How to get the freight based on the order value

Hi Folks,

I have a scenario..if the total order value is less than 2000/- the freight cost will be beared by the customer and if the total order value is more than 2000/- then the company will bear the freight cost. We are using two condition types for freight calculation for this scenario. What can be the way to get this?

useful suggestions will be awarded points.

Sunanda.p

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Oct 06, 2008 at 02:04 PM

    Hi,

    Write a requirement within the condition type as the order value is > 2000/- then pick particular condition, ask your abaper to write rouitne in requirememnt.

    Regards

    Ramki

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 06, 2008 at 02:17 PM

    Hi,

    If you use two condition type for freight, then u may go for condition exclusion.

    Better way is to write a new requirement with the help of an ABAPer and give that requirement in the pricing procedure against the condition type.

    Hope it'll be helpful.

    Regards,

    Venkatesh.S.P.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Venkatesh,

      If we use condition exclusion in this scenario then how the freight can be calculated. please explain indetail.

      thanks in advance,

      Sunanda.p

  • avatar image
    Former Member
    Oct 06, 2008 at 08:20 PM

    Hi all ..

    could you please explain me how do we achieve this through condition exclusion ? As far as i know the condition exclusion is used to compare codnition types in one exclusion group or in two exclusion gropus and pick the or worst conditions ..

    If we are writing a requirement for this.. what are the technical things that we have to tell the abaper?

    thankyou

    bj

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 07, 2008 at 04:28 AM

    Hi

    SUNANDA.P

    U can achieve this by using scale in yr freight condition. Select yr freight condition and go to Tcode V/06 there u will find SCALE TAB -


    scale basis, u select " B ". Now maintain condition scale value 2001 then freight rate will be e.g. 500 rs.

    In VK11u can go to scale by pressing F2.

    Try and this will help you

    Thx.

    Dwarkesh

    Add comment
    10|10000 characters needed characters exceeded