Skip to Content
avatar image
Former Member

Movement allowed indicator

Dear All,

I am facing this problem while planning material components for my project.

When I assign some stock material ( item cat. L) to a network activity, the system does not reflect the same in MB25. But in MB25, if I check the indicator " Goods movement not allowed", it reflects the reservation.

When i go to material component in project structure, I can see that under "proc. parameter" tab, under section "general indicators" the radio button for Movement allowed is not active.

Whereas for another project , this same indicator is active and hence i can see the reservation in MB25.

Can u pls guide me, for what background setting, this "Movement allowed " indicators become active or inactive.

Thanks in advance.

Vikas sharma

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Oct 04, 2008 at 09:16 AM

    Hi,

    When u attch material to activity which is not released the Movement allowed tab is desected at the tyme of releasing the activity goods movment is allowed.

    Movement allowed is depend on status of the activity.

    Rgds

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 04, 2008 at 11:41 AM

    Hi,

    Another factor is the requirement date:

    The reservation management program sets the 'Movement allowed' indicator for requirements dates planning within certain preset time horizon. For requirements which lie beyond this preset time horizon movement is not allowed (for instance, reservations with requirement dates in the far future). The time horizon is set in customizing.

    Further, I think 'planned Independent requirements' are normally created with 'movement not allowed' indicator.

    You can check what applies to your situation.

    regards

    Murali

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 06, 2008 at 04:50 AM

    Hi

    To support Murali's answer...please check whether the movement allowed indicator is set wrt plants in T code OMBN

    Regards

    Add comment
    10|10000 characters needed characters exceeded