Skip to Content
avatar image
Former Member

Data for Keyfigure in DSO displaying zeroes inspite of value present in PSA

Hi,

I am not able to see the correct data for a particular Key Figure in the DSO, it is displaying zeroes for all the records.

Data is being loaded from a DataSource where non-zero values for that key figure are present.

Transformation is direct, no routines or formulae.

Your help required.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Oct 01, 2008 at 07:17 AM

    HI,

    Look into the PSA data that Negative values are present for those Keyfigures.Think both posite and negative values are there for those records which sum up and giving the Zeros in the DSO.Check in the R/3 side table entries for those records.

    Tarak

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      HI,

      Check if there are any old PSA requests and data in those requests.May be having negative records in those requests.

      Tarak

  • avatar image
    Former Member
    Oct 01, 2008 at 07:57 AM

    Hi.....

    Check the data type of the keyfigure........

    Make the update mode overwrite for that DSO..........and then try to load it.....................

    Regards,

    Debjani.....

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 01, 2008 at 10:26 AM

    Hi,

    If it is a non cumulative key figure the you will see data only when you run raport, This data will not be visible directly in DSO/Infocube.

    If it is standard key figure, try to simulate update rules, then you can check what is goning on.

    Regards,

    DL

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 01, 2008 at 03:27 PM

    Hello Rahul,

    In the past this problem has happened because the corrections from the notes 1041000 and 1081423 were missing from the BI

    system. If the notes are applicable to your release level please apply them and then try the loading and the activation of the

    request again. If the problem still exists you can use the note 1052335 to trouble shoot the loading and activation of the

    data in your system. A good tip is to switch of the automatic activation of the data or remove the DSO from the process

    chain if its a process type in the chain that triggers the activation. Then you can check in the activation queue/new data table

    of the DSO to see if the data is correct at this point. If yes then we know at least that the issue happens on activation of

    the data.

    Best regards,

    Des.

    Add comment
    10|10000 characters needed characters exceeded