Skip to Content
avatar image
Former Member

conditional interface determination

Hey folks

I would like to know the difference b/w :

conditional interface determinations Vs conditional receiver determination?

when do we need to use either of these?

Thnx

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Sep 30, 2008 at 07:21 PM

    basically these are used for checking for certain condition dynamically.

    conditional interface determinations :

    This is used to determine which interface mapping to be used based on given condition.

    for eg:- you have one source idoc which shd be mapped to 3 different files, but only one file shd be generated for one idoc, at this point we can determine which file to be generated based on given condition.

    conditional receiver determination

    Here we determine which reciever to be used based on condition.

    for eg:- you are send a Flat file to two FTP servers, based on particular condition, here conditional receiver determination can be used.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 30, 2008 at 07:33 PM

    In simplest words.

    Via conditional receiver determination,you can branch off your messages to several receiver systems(for e.g ECC or CRM or SRM system etc) whereas in conditional interface determination your messages can go to multiple interfaces but within only 1 receiver system(for e.g different IDOC's on same ECC system).

    Thanx

    Aamir

    Edited by: Aamir Suhail on Sep 30, 2008 2:33 PM

    Add comment
    10|10000 characters needed characters exceeded