Error while loading into DTP

[Former Member]

Hi,

I am loading data to a DSO from 0FI_AP_30. PSA I am able to load successfully but while loading this PSA data to DTP i get the following error message:

@5D@ Request REQU_D44GG0YIPPH7NBQ5F1VOCB890 not extracted; request is in obsolete version of DataSource @35@

and in help this is the respose:

Diagnosis

The request REQU_D44GG0YIPPH7NBQ5F1VOCB890 was loaded into the PSA table when the DataSource had a different structure to the current one. Incompatible changes have been made to the DataSource since then and the request cannot be extracted with the DTP anymore.

System Response

The request is in PSA /BIC/B0001232, version 001. The current PSA version is 002. An extraction would lead to a short dump because of field incompatibilities.

Procedure

If you no longer require the data, you do not need to take any further action.

If you do still require the data, you can just extract it by creating a generic DataSource in the Myself source system in PSA /BIC/B0001232, version 001. You can find the technical name of the PSA table in the table RSTSODS with the specified PSA name and version. Convert the data using a separate transformation into the new target format.

Please let me know what can be done for this? pl give me the solution.

Thanks & Regards,

Vijaya

[Former Member · Accepted solution]

Hi,

Try the below steps:

1. Delete the data from everywhere: PSA, Data target etc etc.

2. Re-activate the datasource and then try to load the data back to PSA.

3. Without going to the structure of the datasource load the data from PSA to data target using DTP.

The data should be loaded successfully.

Regards

Rohit

[Former Member · Accepted solution]

Hi Rohit,

i didnt get your 3rd point. Can you please elaborate the procedure?

Thanks & Regards,

Vijaya

[Former Member · Accepted solution]

What I wanted to say here is that sometimes it so happens that we change some setting in the datasource or some structure. In that case it starts giving this error.

The solution I tried for this was to delete the data from PSA and then re-activate the datasource. Then without disturbing the datasource again, reload the data to PSA and then to the data targets.

I hope this works.

Regards

Rohit

[manna_das]

Hi Vijaya,

I am also facing the same error for data source 2LIS_03_BF, i am unable to load the same in one DSO, can you elaborate how you solved your issue ASAP?

I can't run IP because this data source requires downtime in ecc. We have already done that.

Thanks & Regards

Manna Das

[Former Member]

have you migrated the datasource properly into the new 7.0 datasource.

That is the problem.

[Former Member]

Yes i have migrated it properly. 3 days back i was able to load data.

Today i did some changes to extractor so replicated in BI and activated all DSO, transformation, DTP but still get the same error.

Thanks & Regards,

Vijaya