Skip to Content
avatar image
Former Member

a question about "rdisp/wp_no_dia"

I have a question : what is the default value of "rdisp/wp_no_dia" if I do not define "rdisp/wp_no_dia" in profile. and if I define rdisp/wp_no_dia=0 in the profile, then is there no user can logon the sap system from their GUI.

thanks

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 27, 2008 at 01:34 PM

    Hi Victor,

    There is no such default value for the parameter rdisp/wp_no_dia

    Normally at the time of installation the value will be taken by the installation process based on the hardware available. (memory and cpu).

    After installation you can set the value to a different one to your requirement.Mind when increasing the value because it need more resource.The smallest value can be less than 2.You can not even set a value less than 2.

    Regards

    Ashok

    Add comment
    10|10000 characters needed characters exceeded

    • There is no such default value for the parameter rdisp/wp_no_dia

      Yes, there is.... check RZ11

      Normally at the time of installation the value will be taken by the installation process based on the hardware available

      Depending on what version are you installing...

      The smallest value can be less than 2.You can not even set a value less than 2.

      That's a contradiction...

      If you don't or remove rdisp/wp_no_dia from profile, then the default value (RZ11) will take over.

      Regards

      Juan

  • avatar image
    Former Member
    Sep 27, 2008 at 12:04 PM

    Hi,

    The default value for rdisp/wp_no_dia is 2. You cannot put a value smaller that the default.

    Cheers!

    Add comment
    10|10000 characters needed characters exceeded