Skip to Content
0
Sep 26, 2008 at 01:32 PM

Debugger keeps popping up

125 Views

Hello everyone,

I keep having problems with the new debugger in a Netweaver 7.0

Sometimes, I have no clue by which rule, I can not properly leave the debugger. I press F8 when debugging my code to leave the debugger. After this each time I save my coding or try to activate I end up in the debugger again, right in the middle of some SAP coding. Only remedy I found so far is to log out and log in again. Restarting the transaction (/nse80) is not working.

To state the obvious:

- I have no break-points in the code I end up in

- I tried /hx to detach the debugger

Has anyone else experienced this? Is there a note somewhere out there?

Regards

Andre