Lo Extraction

[Former Member]

hi all,

error in LO extraction as

"No extraction structure active or no BW connected".

Thanks.

[Former Member]

good

[Former Member]

Hi,

check

Note 914268 - No extraction structure active or no BW connected

Symptom

Within an instance, you use the NetWeaver components of SAP ERP and BW.

When you execute transactions like to fill rebuild tables in Logistics, the system issues the termination message M2 630:

No extraction structure active or no BW connected

The connection test and the settings for the Myself source system are definitely correctly maintained.

Other terms

OLTP, extractor, data extraction, DataSource, API service, SAPI, RSA2_SERV_BW_CONNECTED, OLI1BW, OLIZBW, OLI3BW, OLI9BW, 2LIS_XX_XXX, M2630, SBIW, LIS, rebuild

Reason and Prerequisites

The problem is caused by a program error.

Prerequisites:

Within an instance, you are using the NetWeaver components of SAP ERP and BW. Thus, potential data loading processes are executed by using the Myself source system connection.

No other BW system is connected for data as a target system.

Cause:

Prior to NetWeaver, you could not operate ERP and BW in one common system. For this reason, the case that Logistics data need to be loaded into the same system for BW functions was not considered. The system as "source system" does not recognize that the system is connected as a "BW system".

Solution

To correct the problem, you need Service API 7.00 Support Package 08 or PI 2004.1 4.6C Support Package 13 in the affected source system. The attached composite SAP note informs you on which software components contain Service API 7.0 and lists the corresponding Support Packages of these components.

Alternatively, implement the attached program corrections.

In the BW system, you only need to implement the correction if the BW system is affected in its role as a source system for itselt (myself connection) or for another BW system.

Caution: Service API is an internal component. Therfore, it is not delivered separately but as a part of other software components: PI, CRM, PI_BASIS and several others. Thus, a composite SAP note is created for each SAPI correction note. This composite note describes which Support Packages of the above mentioned software components contain the SAPI correction. However, the composite SAP note will only be released when the corresponding SAPI Support Packages are released.

hope this helps.