Skip to Content

Problem in Report Execution

Dear All,

There is an existing executable report whci is a copy of MB51 and made a ZMB51.

Now if I give this transaction ZMB51,on the screen i can c compiling..and the selection screen does not come.

Now If i execute the report from SE38,nothing happens and remains at SE38 screen only.

If I go inside the report and do Direct Processing,it comes back to the SE38 initial screen.

What might the problem?

Please Help.

Rahul Bhat.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 26, 2008 at 06:40 AM

    Hi,

    There will be leaks and tracks when you copy the standard program into ZTXcode. There might be lot of reasons for that wise includes of MB51 might not be copied properly check them might be solving your problem.

    But when you are transporting the program there might be problems.

    Cheers!!

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 26, 2008 at 06:34 AM

    See the nature of transaction and investigate on that lines...

    Raghav

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 26, 2008 at 10:00 AM

    There was a problem with the internal table declaration,the corrections for which i made.

    But I still have not understood the reason behind this as to what relation does the internal table structure have with execution report if the program is syntatically correct.

    Thanks to all again.

    Add comment
    10|10000 characters needed characters exceeded