Skip to Content
avatar image
Former Member

Printer setup

HI Friends,

I had a requirement from client to change printer from XX12 to YY46 for printout for Billing (F2). Both the printers are LaserJet.

Printers are maintained in communication method at condition record of output type. If it is maintained at condition record level how can it be moved from DEV client to Production client.

Is there any settings in IMG to change the required printer (Output device)?

Thanks in advance

Regards,

Vamsi

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    Sep 25, 2008 at 08:09 PM

    Hi,

    Check with your basis person to configure the new printer in the production system. They can also transport the same from DEV to Production system.

    Regards,

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 26, 2008 at 01:15 AM

    I dont think any additional config is required. Change the defualt printer in your control panel printer settings to the new printer and you should be able to take prints from the new printer.

    Regards,

    GSL.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 07, 2008 at 10:56 AM

    the last action was before two months, so I close this thread

    Add comment
    10|10000 characters needed characters exceeded