Skip to Content

Equipment created is not showing in IE02, IE03 and in table EQUI, EQUZ etc.?

Dear Experts,

When I am creating Equipment using IE01 and saving it, it is showing Equipment XXXXXX is created. But when I go to IE02, IE03, it says Equipment XXXXXX does not exist. I even checked the entries in the table EQUI, EQUZ but the equipment was not showing there. How to resolve the issue?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Apr 13, 2018 at 06:36 PM

    I had earlier faced similar issue with maintenance plan but that was a single case. So we ignored it. Try to take help of technical team and debug the code. Also look for any custom code that have been put in place in IE01 & may be causing the issue.

    If this doesn't help you need to raise a OSS message to SAP.

    Regards

    Add comment
    10|10000 characters needed characters exceeded

  • Apr 13, 2018 at 09:34 PM
    • No UpdateErrors (Trx."SM13") when Creating the Equipment?
    • Check with ABAP-Team on Enhancements / UserExit / BAdI implemented?
    • Execute Trace - See what actions / Table-Reads are performed and which not ...
    • Use the above as Information for a SAP-Incident (SAP Support) if no Solution / Cause was found ...
    Add comment
    10|10000 characters needed characters exceeded

  • Jan 29 at 07:29 AM

    Hi,

    I suppose that this is due to serial number functionality. This equipment is inactive and can't be seen in IE03.

    Equipment master record is created automatically only when the serialization procedure in serial number profile is set to 02. In that case you can see the equipment record in IE03. If it is set to 01, you need to activate it manually in IQ02. A record in EQUI exist in either case but not in EQUZ and EQKT in the second case, though.

    There is detailed explanation on following link https://archive.sap.com/discussions/thread/3222060

    BR, Yauheni

    Add comment
    10|10000 characters needed characters exceeded