Skip to Content
avatar image
Former Member

Problems with SLD

Hello,

I have two interfaces, the first is a file to bapi interface and the other is a file to IDOC interface. How many products, software components, technical system and business system I need?

Thanks.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

6 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 24, 2008 at 01:25 PM

    hello Carlos,

    very thanks by your answer.

    We have seen your profile, you are spanish. Have you any problem if we write you to personal mail?

    very thanks in advanced,

    silvia

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 24, 2008 at 11:09 AM

    Hi,

    If you are using these two interfaces betweene two systems then you can use 2 technical and business systems and 1 product and software component.

    It depends on your requirment.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 24, 2008 at 11:17 AM
  • avatar image
    Former Member
    Sep 24, 2008 at 11:33 AM

    hello,

    very thanks by your response, however the problem is:

    we have two interfaces

    1.- interface file-to-bapi with 2 technical system (sender system and receiver system) and 2 business system (one for each technical system)

    2.- interface file-to-idoc with other 2 technical system (sender and receiver system = the same technical system that file-to-bapi interface) and other 2 business system (one for each technical system)

    when we activate the second interface the follow error occurs:

    'Activation of the change list canceled Check result for Service | bs_filetoIDOCReceiver: SAP system ID VR2 and client 100 already exist in service | ts_flatfile_bapi_receiver'

    how solved we the problem?

    very thanks

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hola Silvia,

      You have to play only with two tecnichal systems and two business system. And use them in the two scenarios.

      TS1 --> XI --> TS2

      BS1 --> XI --> BS2

      Scenario1: File to BAPI.

      BS1 (your File System) --> XI --> BS2 (Your R3_BACKEND- BAPI)

      Scenario2: Ffile to IDOC.

      BS1 (your File System) -->XI --> IDOC (Your R3_BACKEND- IDOC)

      To make easier the issue, use Business Service instead of using Business System in case of BS1.

      Doing that you avoid creating TS1 and BS1 in SLD.

      Hope that helps you.

      Carlos

  • avatar image
    Former Member
    Sep 24, 2008 at 02:13 PM

    hi Carlos,

    we send you a mail to your personal account,

    very thanks by your help,

    silvia

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Shiva,

      In the above scenarios you are creating the Two Business Systems for same R/3 Systems. Is this right?

      In first case alreay you created Business system for BAPI.

      So you can use the same Business Systemf or sending the Idoc form XI to R/3 System instead of creating the another Business System.

      I also faced the same problem once, by reusing the same Business System I resovled my problem.

      Regards

      Sridhar Goli

  • avatar image
    Former Member
    Sep 25, 2008 at 01:02 PM

    Thanks very much to everybody.

    The problem had been resolved. The solution is to use the same business system in both intefaces.

    silvia.

    Add comment
    10|10000 characters needed characters exceeded