Skip to Content
avatar image
Former Member

[Middleware] Table CRMOBJECT configuration.

Hi all,

I would like to know more about table "CRMOBJECT" in ISU (upload datas from ISU to CRM). In our system I havenu2019t any logical system populated for the following CRM object: BOM, BUPA_REL, BUS_TRANS_MSG and SERVICE_MASTER. How to set this table, whatu2019s the best configuration? Is it dangerous to keep this table like that?

Thanks in advance for your details.

Best regards,

Nicolas

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Sep 23, 2008 at 05:48 AM

    Hi Nicolas

    You do not maintain the table directly, but instead look at the corresponding objects in the object management of master data (tx. r3ac1), customizing (r3ac3) and condition objects (r3ac5). You can there define the flow control "from which system to which system the data should go" and the way it will be processed.

    Regards, Kai

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      REM_LOGSYS should be the logical system of the remote system. Are they maintained correctly (SPRO->CRM->CRM MW->Comm Setup->Set Up Log. Sys->Define Log. Sys)? They should also contain the logical systems of the ERP clients connected.

      Here in my reference system (5.0) I do not yet have this field so I cannot check - I guess you are using 2007?

      Kai