cancel
Showing results for 
Search instead for 
Did you mean: 

o4 inspection

Former Member
0 Kudos

hi experts

when i receive goods for my production order,here comes a problem 'change the inspection stock of material xxx in qm only',i have alreally asigned the inspection type '04' in qm view for the material,does anyone knows how it comes,and how to do

details as follows:

Change the inspection stock of material xxx in QM only

Message no. QA495

Diagnosis

You want to make a stock posting to/from the inspection stock. This is not allowed for material 101001 because the quality inspection control has been activated by QM.

The following cases can occur:

The inspection stock should be increased, although an inspection is not foreseen for the current goods movement

The inspection stock should be released, although you can only do this using the QM transactions.

System Response

You cannot carry out the stock posting.

Procedure

Check both the QM inspection setup data and the movement type for material 101001 in the quality management view of the material master.

Exception:

If you post a return delivery to a vendor with reference to a purchase order, or cancel a goods receipt, the stock indicator from the order is proposed.

Check and modify this proposal as required.

The stock may have been transferred already and is therefore no longer in inspection stock.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi,

If you put in QM/MM forums then you will get immdiately proper solution.

Anil

Former Member
0 Kudos

hi,

i can't find qm forum,does it exist in sdn?

best regard

zlf

former_member187991
Active Contributor
0 Kudos

hi

what is process you are doing exactly ,if you have activate the QM then while making the GR for process order system will create an inspection lot ,which result recording should be done and make the usage decision then post the material to stock

can you explain briefly

also you can post QM relevant problem in PLM forum

regards

thyagarajan

Former Member
0 Kudos

hi thyagarajan,

as you explain,i wanna system create a lot which is 04 type ,while when i use tcode mb31 for order receiving,here comes the problem,i think a lot should be created and materail doc. posted but not the problem

best regards

zlf

former_member187991
Active Contributor
0 Kudos

hi

after receiving the stock where the material is lying or whether while making MB31 this error is coming.

kindly check 04 is active in Material master

regards

thyagarajan

Former Member
0 Kudos

hi thyagarajan

thanks for your answer,04 is active,if not active,i can confirm order directively

best regards

zlf

former_member187991
Active Contributor
0 Kudos

hi

ok i asked about when you are encountering the problem ,kindly reply

regards

thyagarajan

Former Member
0 Kudos

hi thyagarajan,

confirm by mb31,and when i click save button

best regards

zlf

former_member187991
Active Contributor
0 Kudos

hi

check whether any inspection lot is created with reference to the production order and also any other inspection type is active

regards

thyagarajan

Former Member
0 Kudos

hi thyagarajan,

searching lot in qa33 by order,nothing i can found,that means lot lost,well if i set key 03 to the material,when i create order,lot can be found,that means 03 lot is correct,but 04...and if i set 03 and 04 to the material together,just 03 ok,so ,i doult if 04 should be set something special in spro,

Answers (0)