Skip to Content
avatar image
Former Member

decimal point inconsistency in QA32

In inpn plan, for some charecteristics I maintained 2 deimal point, but during result recording it is considering 3 decimal points.

Ex Decimal point in QP01- 2- if I enter 13.234 , it will accept the reading and it can be saved. While in specifications lower - upper it is rounded to 1 decimal.

Same time if I enter 13.2345, system is throwing warning of max decimal restricted to 3, but in plan it is 2 decimals.

Could anyone tell what is the reason for this deecimal point inconsistency

Thx in advance.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Sep 22, 2008 at 10:17 AM

    Hi Jaison, Check,,,,,,,,,,,,,, In SPRO>>>Quality Management>>>Maintain Settings at Plant Level Execute. Now check for the plant settings for the plant where this is happening. In the result recording Tab, check the value in the field "Additional decimal places". Make it null. You query will get resolved. Regards, Shyamal

    Add comment
    10|10000 characters needed characters exceeded