Skip to Content
avatar image
Former Member

OUTPUT FOR QUOTATION

Dear friends,

for quotation my output type taking Logical destination as AdobePDF by default, we want to change it to Local LOCL Local printer. Can you please guide me how to do this

Thanks & Regards

Vishal

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 22, 2008 at 05:28 AM

    Go T-code--NACE

    There u can find all the output types and procedures and condition records and Access sequence.

    There check the output type and check with condition records and there u can enter the output type for Quatation and select the document type and Press Communication tab

    There u can fine output device and layout module etc..

    If u dont have Print Parameters then u can define in spro in output determination.

    Revert me if u have any doubt

    Regards

    Srinivas.

    Edited by: srinivasarao p on Sep 22, 2008 7:28 AM

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Go to NACE

      1.Check V1--Sales

      2.Click Output Types

      3.Click Quotation Output Type

      4.Click Output type and Click Processing Routines

      Here check where any local print is defined in this routines

      if u not find then make new entry and add in Processing Routines.

      5.Go to Condition Records it will take (T-Code-VV11) there u have define the document type and partner function.

      After that click line item in Condition Records and go to Communication Tab .. In that u can set Output Device and mandatory click print immediately and release output type.

      Then save the condition records and raise quatation once and check your output of Quatation.

      if any doubts revert me...

      Regards

      Srinivas.

  • avatar image
    Former Member
    Sep 22, 2008 at 05:28 AM

    Hi

    LOCL is the Logical printer and not the Local printer. Please check if your local printer is available in the drop down list of the printer. If not available, then configure the local printer.

    Thanks,

    Ravi

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 22, 2008 at 05:49 AM

    thanks a lot

    But agian now new problem I can not see print priview in DISPLAY MODE i need togo to change mode always

    Edited by: WISH on Sep 22, 2008 7:49 AM

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      u can see print preview in display mode in Change mode of Quatation and Click ExtrasOutput -


      Edit/Print Preview-

      If u click Edit u can change the output device or any other information .. But in Display it will directly goes to Print Preview..