Skip to Content
0
Former Member
Sep 19, 2008 at 09:59 AM

Inspection Lot For Calibration Order

293 Views

Dear All,

I want to create a Calibation Order for equipment. I have craeted a general task list, assign master inspection charaterstic in the operation using the control key QM01.

Now I am assigning this task list directly to the order and releasing the order. A inspection lot is being created, but I am not able to make entry for the results for that inspection lot.

Status is showing CRTD PASG.

Pl tell the possible reasons for that

Thanks

Mudit Gupta