cancel
Showing results for 
Search instead for 
Did you mean: 

Printing PO's using Crystal Report

former_member187989
Active Contributor
0 Kudos

Hi,

I am printing Purchase order using crystal reports. And when I print single PO, it is printing perfectly and I am printing one PO per page in pre printed stationery. But when I Print Multiple PO's i.e., mass printing, the first record gets printed correctly but when the printer scrolls to second page, the header section jumps one line above and when it scrolls to third page, it jumps two lines above and so on. And I am using continous stationery in dot matrix printer. How to print multiple PO's with Correct page header alignment. (Also I found the same problem when I print A/R Invoice).

Thnx in Advance.

Regards,

S Desikan

Accepted Solutions (0)

Answers (3)

Answers (3)

former_member187989
Active Contributor
0 Kudos

Gordon,

Where i can download Generic print driver ?

Jeyakanthan

Former Member
0 Kudos

You can lookup printer maker's website to check. Some printers have abilities to imitate other printers. Hope you are lucky.

Thanks,

Gordon

former_member187989
Active Contributor
0 Kudos

We have done enough with page settings in report,it' ok for

single page printing.

Is there is any adjustment to do with printer,to print

properly in continuous pages ?

We are using printer Wep LQ DSI 5235.

Jeyakanthan

Former Member
0 Kudos

This model sounds not in the support list. Do you use a generic printer driver to imitate the supported driver?

former_member583013
Active Contributor
0 Kudos

Jeyakanthan,

Please see the supported printers

Suda

Former Member
0 Kudos

Dot matrix printer has the inherated weakness for linefeed control.

You have to change the page setting quite a few times before it can be fit.

If possible, laser printer will be much better. What you see is what you get.

Thanks,

Gordon