Skip to Content
avatar image
Former Member

WebUI transaction launcher in ECC delivers only empty screen

Hello,

we need to launch ECC-Transactions VD03 (or XD03, VA03 etc) in WebUI. In order to do so, the following steps have been made:

- create ZTSTC

- define ITS URL with CRMS_IC_CROSS_SYS

- configure transaction wihr CRMC_UI_ACTIONWZ

- integrate the URL into the NavBar

When I now try to start the transaction, the following text apears on the start screen:

The object you have selected is starting in a new browser window. You can continue working normally in the current application. However, you may have to navigate back to the page you were working on

A separate window opens, where the URL ..../bc/bsp/sap/crm_ui_frame/genericpos is the only information listed.

Any ideas or similar experiences? Thanks for your support.

Regards,

Markus

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Sep 15, 2008 at 06:38 PM

    Please check whether your RFC connection is working or not.

    Also check whether your Port is opened, if yes you should be able to launch a transaction out there.

    Regards

    Arun kumar

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 16, 2008 at 06:26 AM

    Hi,

    If you are trying to launch an ECC transaction, simple way is to go with URL .

    Create a URL with parameter for required transaction. Using this create a Launch Transaction ID.

    Hope this helps,

    Regards,

    chandan

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi Marcus,

      I just solved this issue I have been facing since long now. I have a thread on it if you need to check:

      Format of an ITS URL

      The ITS URL which you need to specify is:

      http://<server>:<port name>/sap/bc/gui/sap/its/webgui/!?transaction=<ECC TRANSACTION>&okcode=ICEXECUTE

      In the above mentioned URL , you will have to replace the server name and the port name ofyour ecc server. Similarly replace the transaction code with the ECC tx.code you need to launch.

      Hope it helps. For further information regarding the transaction launcher, you might find this thread very useful: open report using transaction launcher

      Regards.

  • avatar image
    Former Member
    Sep 23, 2008 at 11:48 PM

    Hi Markus

    Did you find a solution for this issue? If so, could you please share the solution. We have the same issue.

    Thanks a lot,

    Best regards

    Stephanie

    Add comment
    10|10000 characters needed characters exceeded