Skip to Content

inspection characteristics.

Hi guys

i have three inspection characteristics to be performed for a particular operation.i have assigned the three inspection charectoristics in my operation(workcenter) in routing.is there any chance to confirm each inspection in co11n.my task is to check whether these inspections are performed or not in the operation.

and with out performing one inspection the operation should not go forward.

  • all the three inspections are in only one particular operation****

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Sep 13, 2008 at 03:37 AM

    Hi Deepu,

    In OPK4 - Define control parameter, select your plant & Order type.

    In this 1st tab page select QM results - Error Message if no inspe results.

    So when you confirm without QM result, system will throw error message.

    For any query revert.

    Regards,

    S.Babusingh

    Add comment
    10|10000 characters needed characters exceeded