Skip to Content
avatar image
Former Member

CO-Cost estimate

Hi All

While running cost estimate the price for a particular Raw material for which the price control is MAP (V) is picking the standard price instead of V while the stratergy sequence in valuation variant is price control i.e.Valuation Price according to price control in Mat Master.

Thanks in Advance

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Sep 11, 2008 at 12:21 PM

    Dear Vinay, Double check at your end whether the price control was different on the date of valuation date in the Costing run. If you are sure, the system is picking up the wrong price, you can very well post a message to SAP asking for clarification and OSS notes to set right. Trust this helps much! Cheers, Ashok SINGH

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 11, 2008 at 03:57 PM

    Hi Vinay,

    I'm also facing same issue,could you please let me know what did you find out.

    Thanks,

    Anusha

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 12, 2008 at 12:01 PM

    Hi,

    Please review the field in Material Master for the specified material, 'do not cost'. It should have been checked if it is raw material indicator 'V'

    Regards,

    Ashok

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 12, 2008 at 01:34 PM

    Dear Vinay

    Please check the Material master costing view and accounting view especially price indicator. similary you have to verify the valuation variant what sequence you have identified to calculating the material price etc.,

    Regards

    Sunil

    Add comment
    10|10000 characters needed characters exceeded