Skip to Content
avatar image
Former Member

How to disable debugging?

Hi i have a module pool program. I want to disable the debugging mode for that program which we do using /h in the command field. How can we do that?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Sep 10, 2008 at 07:06 AM

    Contact your basis they Will be able to provide the Help to Disable the Debugging option, this is possible with Authorization. But i am not sure this can be done in the Object level. just check with your basis.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 10, 2008 at 08:05 AM

    Hi,

    Remove all the stop points in the Program, it will work as if there is no debuggging.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 10, 2008 at 11:31 AM

    hi,

    remove all the break points in your module pool program then it will not go into debugging . it will directly run.

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 15, 2008 at 01:00 PM

    Hi,

    1)you may mark the programme as a system programme at the programes attributes. After that /H would'nt work anymore unless system debugging is switched on.

    2) If the code is more sensible but short (i.e. authority-check raising an error) you may defien a makro for that purpose (DEFINE my_makro. ... END-OF-DEFINITION).

    3) If the input of licence numbers ore similar pocedures are affected you may hide the code. Ask SAP directly how to (you should be a partner than - or have at least your registered namespace.)

    kind regards,

    Holger

    Add comment
    10|10000 characters needed characters exceeded