cancel
Showing results for 
Search instead for 
Did you mean: 

No source bin found

former_member208541
Participant
0 Kudos

Hello,

while picking in delivery throug a transfer order, i have two issues . iam an sd consultant and since iam not awar of wm config but i need to know the following

1) sometimes the system is not able to find the source storage bin and so iam not able to do the picking. what to do. do i need to check some master data or need to check some config.

2) sometimes , my systems picks up more quantity automatcially than the delivery quantity when creating a transfer order. what to do ??

regards

sachin

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

For your first issue, both frenchy and csaba has answered, I completely agree with them,if you will check your strategy config u can fix the issue.

For your second issue, this happens when u mark the indicator "Full stock removal requt active" in defining the storage type in spro->le->WM->master data->define storage type.

This indicator activation means that during stock removal the entire quant is to be removed from

storage, regardless of the quantity required.

Excess quantity is put back to the same bin or the other if you have given "return storage type" in the config

Answers (2)

Answers (2)

Former Member
0 Kudos

Sonu

Hi

The first error message is quite simple.

When you try to create a TO for picking the system looks at your st type search strategies and then looks in those areas to pick, If it does not find any stock in those areas you get your message.

For instance if you had st type 001 002 and 003 and your strategie was 001 002 then the system would search in 001 first and then 002 and then stop.

If you have a preference for the search you should set this but remember it will stop after it has searched what you say so if you want it to search there and if it does not find anything then get it from anywhere then after you have 001 002 use *** which means search anywhere and everywhere to find the stock.This means that you will only get the error message when there is genuinely no stock.

For the second error message you must have a strategy that telle the system to pick a full qty of tyhe bin or something. There are various stock removal strategy options and you should check them in your st types and make sure you have the right one. A populat one is 'F' which is FIFO First in First Out which will pick the oldest first based on the goods receipt date.

I hope that this helps

Frenchy

csaba_szommer
Active Contributor
0 Kudos

Hi Sonu,

1) sometimes the system is not able to find the source storage bin and so iam not able to do the picking. what to do. do i need to check some master data or need to check some config.

Check your settings here: SPRO > LE > WM > Strategies > Activate Storage Type Search (Storage Section Search, etc).

(here you can define search sequence)

2) sometimes , my systems picks up more quantity automatcially than the delivery quantity when creating a transfer order. what to do ??

Maybe you are using SU management, where it is possible to set complete removeal your SUs. 'Round off requested quantity for stock removal' may be also active.

Check your settings in SPRO > LE > WM > Master Data > Define Storage Type, here check 'Stock removal control' tab.

(??? - I'm not sure what your problem is...)

http://help.sap.com/saphelp_46c/helpdata/en/c6/f8386f4afa11d182b90000e829fbfe/frameset.htm

Regards,

Csaba