RFC to Mail Adapter Senerio.

[Former Member]

Hi Experts,

I am working on the RFC to Mail Senerio..I think all settings are complete...and communication channnels are working fine!! After executing the Function Module...cant see any messege in sxmb_moni. In the ID, when I went to TOOLS - TEST CONFIGURATION, and did the necessary settings..and placed the load, it is giving an error like this....cant make out!!

Receiver Determination

simulation. Then right click and select Activate service.

(Also see SAP Note 517484)

Friends,,, now my simulation is perfectly OK. But I still donno, why I am not getting any messege IN SXMB_MONI . No Emails either!!

Pls help!!

Arnab Mondal

Edited by: Arnab Mondal on Sep 5, 2008 4:03 PM

[Former Member]

Hi Arnab,

While configuring the RFC sender communication channel you should make sure that the communication channel should be activated and immediately you need to create the RFC in R/3 of type TCP/IP.The program id should be same as in communication channel.

Have you done the same?

Regards,

Sharath

[Former Member]

Sarath, It has been done.The mistake that I made was in ID. Once I finish, I will intimate all.

Arnab