Skip to Content
avatar image
Former Member

SEM: Management CockPit Frame Creation issue

Hi ,

In sem i am facing an issue in management cockpit while creating the frame for the dash board.

issue: while creating the frame in data source,measures selection f4 drop down for the Info cubes are not appearing for all info cube and queries only a partial list is getting displayed 4 to 5 list,but i have more than 100 cubes are available in my bw system.

please suggest me the solution.

Harsha.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

1 Answer

  • Sep 05, 2008 at 07:42 PM

    Hi Harsha,

    There can be many reasons for this. Firstly check if you are looking up the cubes for any RFC destination. If you are looking up cubes in your local BW, then the RFC destination should be blank. Secondly check if you have access to all the cubes that you want. Thirdly, make sure that you clikc on all values and not just the historical values you accessed last time. Finally, if you are using measure catalog, then you can't change the infocube in the data source.

    Regards

    Pravin

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Harsha,

      Also if you are trying to see the infocube related to a specific query that you created, please see to it that the query is released to OLEDB in the query properties. You should be able to see that cube in the data source then.

      Regards

      Pravin