Skip to Content
avatar image
Former Member

Recrods not extracted into BW

Hi,

I'm using a Function Module for extracting data from R/3. I tested the DataSource using RSA3, its working fine and pulling records for the specified criteria. Now, I'm trying to pull data into BW by specifying the same selection criteria as in RSA3. The load is successful but its not pulling any records and I get the below message in Status Tab

No data available

Diagnosis

The data request was a full update.

In this case, the corresponding table in the source system does not

contain any data.

System Response

Info IDoc received with status 8.

Procedure

Check the data basis in the source system.

Message in "Step By Step" Analysis

Diagnosis

The data request was a full update.

o In this case, the corresponding tab

contain any data.

o System Response

Info IDoc received with status

Procedure

Check the data basis in the source system.

Can anyone please tell me why the records are not pulled into BW even though I have the records in the source system and I'm able to extract those records in RSA3

Thank you!

AM

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 04, 2008 at 05:09 AM

    Hello,

    There migh be a prblem in the functionmodule code, In the status message it is clearly showing that data was missed in the corresponding tables.

    And also there was some problem in maintaining Joins and loops. Do the necessary changes in the code.

    Bye,

    Chandu.

    Edited by: chandu guduru on Sep 4, 2008 7:09 AM

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 04, 2008 at 01:42 AM

    Hello AM,

    This issue happened to me once....... The proplem is definately with the Function Module....

    Please check the code of the Function Module........ Please check whether all the loops are closed properly......

    Check how many records get populated in RSA3 (by giving some value for number of records/ per call)........ and then change the number for the NUmber of records per call in the RSA3 and run again...... Check whether you are getting the same amount of data

    If possible please send your existing function module code........ We can try checking it...........

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 04, 2008 at 08:24 AM

    Hi,

    If the data is not large, try loading with no selections.

    BR/

    Mathew.

    Add comment
    10|10000 characters needed characters exceeded