on 09-02-2008 9:14 PM
I tried doing unit conversion at material grid level. it is showing all key figures as zero ?,
if i remove the conversion then the number are showing up right in Base UOM
did any body face this issue ?
thanks in advance.
Aravind
Hi,
You can maintain the number of decimal palces for your Cases in the table T006. The field is ANDEC - No. of decimal places to which rounding should be performed.
Regards.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Whats your conversion and how is it maintained??
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Gokul,
Thanks for responding. I am converting from eaches to cases. Let us say, 100 eaches = 1 case.
if my quantity is 100 it is showing up as 1, if it is 60 it is rounding up 0.6 to 1 and showing as 1 case. The main problem is, if the qty is 30 then the covnersion fraction is less than 0.5 and it is rounding it to 0.
i tried making my key figure to show up decimals like 0.00, but still the conversion is being rounded to zero.
did you face this earlier ? if so how to deal with it ?
Thanks in advance,
Aravind
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.