Skip to Content
avatar image
Former Member

Conditions in workflow not responding

Hello all!

I have a question about the behavior of the conditions in a WF, because when a WF is triggered, the conditions are not responding. The thing I have to do is go to SWUS and test the WF from beginning to end and then the problem is gone. Why is that?.

Regards IA

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Sep 03, 2008 at 04:00 AM

    It depends on the element that you are using. It may happen that you are using an element whose value does not get populated when you are triggering from standard Tcode. May be it is timing issue. Just create a wait for step that executes a task that executes the method "WAIT up TO 100 seconds"

    Thanks

    Arghadip

    Add comment
    10|10000 characters needed characters exceeded

  • Sep 03, 2008 at 07:23 AM

    When is this happening and at what system? Is it after you transported changes to a QA system or on the DEV?

    Regards,

    Martin

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Martin Nooteboom

      Yes, 100% sure. I've read the container after the execution of every elemnt in the interface and the values are being set correctly, this is why is so odd =/.

      Regards