Use of Router Header Status Code 9 - "Withdrawn"

[Former Member]

Hi Folks ,

We have a significant number of material numbers that currently have

routings - but are being converted to Phantoms. Normally, this would

mean deleting the routings. However, since a significant amount of

effort went into creating these routings, (and they may possibly be

needed again someday), we do not want to lose the information. So - my

question is - if we leave the routing intact, and change the routing

status in the header to 9 (Withdrawn) - would this have the desired

effect of saving the routings without causing additional problems

elswhere? Or - is there an alternate solution?

[Former Member · Accepted solution]

I donot know what is 9 - withdrawn

Can you tell me what is the setting for 9 in OP46?

Status 9 may be relevant only for your client.

[Former Member · Accepted solution]

In OP46 We have assigned 9 for WITHDRAWN and the setings are none of them have been ticked (Rel Ind , Cstng , Cons Chck)

[Former Member · Accepted solution]

that means it cannot be used anywhere like it is CREATED status.

It is okay for your purpose.

But My sugession is why are you changing the status.

Since it is Photom assembly there will not be any production orders for this and most important is whether you want the operatios to be considered for next assembly or not?

Anyhow sinec it is not used directly in production order, you can still have the status 4(released for all).

pl come back

[Former Member · Accepted solution]

Thanks Rajesh,

I got a good understanding and i have maintained as 4 " RELEASED" since my material is maintained as Phantom and i dont necessarily change it to " WITHDRAWN" .