Skip to Content

DYNP_TOO_MANY_RADIOBUTTONS_ON

Hi,

I am getting the runtime error DYNP_TOO_MANY_RADIOBUTTONS_ON when using variants which selects the radiobutton.

PARAMETERS: p_ld1 RADIOBUTTON GROUP radi USER-COMMAND uc01,

p_ld2 RADIOBUTTON GROUP radi,

p_ld3 RADIOBUTTON GROUP radi,

p_ld4 RADIOBUTTON GROUP radi.

While I navigate from radiobutton p_ld4 to p_ld1 through varaints I am getting this error. In debugging mode I noticed that p_ld1 as well as p_ld4 is selected where as only the radiobutton p_ld1 should be selected. If I don't use variants this is not occuring and only the p_ld1 is selected.

Also when I navigate from any other buttons except p_ld4 using variants this is not occuring.

Please help.

Regards,

Soumya.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Sep 01, 2008 at 11:41 AM

    hi,

    in one of the AT SELECTION-SCREEN events you assign values to one of the radiobuttons... Just check your code...

    hope this helps

    ec

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi,

      If you are getting dump when you select the report variants, delete the variant or overright it and save once again. Then run the program. The dump will not be coming again in this case.

      Regards - Senthilraj Selvaraj

      Edited by: Senthilraj Selvaraj on Jul 22, 2009 5:44 PM

  • avatar image
    Former Member
    Sep 01, 2008 at 11:54 AM

    Hi Soumya,

    Gothrough the following link,

    handle-the-exception-on-radibutton

    I hope this will help you,

    Regards,

    Harish

    Add comment
    10|10000 characters needed characters exceeded