Skip to Content
avatar image
Former Member

CAT entry

Hi,

CAT2 is recording time against the WBS element but CAT5 says no record found to transfer.

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Sep 01, 2008 at 08:56 AM

    Hi vinod

    If u have done the time booking on a WBS Element then CAT5 transfer shall not work. U have to do Transfer to controlling CAT7 transaction. Check it out.

    Regards

    Murali

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 01, 2008 at 05:22 AM

    Hi Vinod,

    CAT2 records the time against Network & Activities,where you need to maintain Controlling area ,Sender cost Center, Activity Type, Work center, Plant, Network & Activity number.

    In the initial screen select the Data Entry profile & Personal Number, i.e derived from HR.

    If you have maintain the above then chck in Data Entry Profiles Under default values if you have maintain Wage Type if yes then pls remove it.

    [time-sheet]

    Regards'

    Syed

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 01, 2008 at 07:50 AM

    I can think of following conditions:

    1. Verify table CATSPS table and check for the 'Transfer' field to check if the time is already tranfered.

    2. The time entry will reach the CATSPS table only after it is approved. Check if the CATSDB has the time records.

    regards,

    Ramesh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      In CATDB i am able to see the entry of 8 hours,but in CATPS its not transffered,but in approval transaction with status 30 i am able to see it as approved.