Skip to Content
avatar image
Former Member

Incorrect data in planning buffer ...

Hi,

I experience the following problem:

I have a workbook with two tabs: one to plan quantities and a second one to calculate values using the quantities in the first tab.

On the second tab we have a revaluation function to revaluate the unit rate or the value. This works fine. On the first tab we have planfunction which calculates the values on the second tab using the quantities of the first tab, followed by a save. This also works fine. The problem we run into is that from the moment we change the values of the second tab, by executing the planning function on the first tab, the revaluation function on the second tab does not work anymore when we execute it afterwards ... When executing this revaluation function, it does not select any record anymore (0 read, 0 changed, 0 deleted). Even if we close the workbook and reopen it still does not work. Only when closing the Bex Analyser and go back into the workbook, the revaluation works again ...

-> it appears there something goes wrong in the planning buffer?

Did anyone experience also such problems.

regards

Dries

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Sep 16, 2008 at 02:46 PM

    Hi,

    Even I feel this is the problem with the planning buffer.

    One solution would be to have an exit function with the API "API_SEMBPS_POST" followed by "API_SEMBPS_REFRESH".

    The first API is to save the data and the second one to refresh the planning buffer.

    Please award points if helpful.

    Add comment
    10|10000 characters needed characters exceeded