Skip to Content
avatar image
Former Member

MIGO - PO doesn't contain any items

Dear Gurus,

Did the stocktransfer through sd route from one plant to another depo, then did the replenishment delivery through VL10B, then did the proforma invoice and then the excise invoice, then we've also observed the stock in MB5T falling in stock -in-transit.

Now while doing MIGO , given the Po no and pressed enter it says PO doen't contain any items. the items are not copied from PO to Migo, it give the above message. please suggest

When i did the same scenario in development evrthing was through. this problem occurs in production

Please advise

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Aug 13, 2008 at 02:07 PM

    Dear,

    Please check Purchase Order.

    Enter t-code ME23N.

    Enter your purchase order. Go Item level in Confirmation tab available in purchase order item detail level.

    Check in Confirmation Control Key"Tracking: Import" is exists.

    If yes than remove it from ME22N and save purchase order than try for MIGO.

    NOTE: - Check it each item wise for purchase order.

    Regards,

    Mahesh.

    Edited by: Mahesh Wagh on Aug 13, 2008 4:23 PM

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 13, 2008 at 01:15 PM

    Hi,

    Please check goods reciept is activated or not for that PO..

    Regards

    sankar

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 14, 2008 at 10:18 AM

    Dear D V,As this is stock transfer PO, you have to go Goods receipt w.r.t. Outbound delivery no.

    Please try & respond.

    Regards,

    PramodKumar

    Add comment
    10|10000 characters needed characters exceeded