Migrating workflows from a 4.7 system to ECC 6.0 system

27 Views

Hi,

I have workflows in a 4.7 system which will get used in a newly upgrade to ECC 6.0. Has anyone had problems with this? Is it okey to transport

an old workflow to be used in a 6.0 system? What do I have to bear in mind when doing this and is it easier to rewrite the workflow in the new system than to

look for differences between the old and the new system?

If you think that it is okey to change the old workflows - do you have any guide about this? What is different and what do I need to think about. I would

very much like to have your recommendations concerning this.

Thanks,

Kristina

Edited by: Kristina Hellberg on Aug 11, 2008 4:33 PM

Edited by: Kristina Hellberg on Aug 11, 2008 4:34 PM