BP Settings

[Former Member]

I am doing Master data settings in ISU & CRM .

My scenario is as soon as BP is created in CRM ,that BP should replicate in ISU .

for this ,

In both the systems , I have created number ranges and assigned to grouping .

I know that replication can be done through middleware .Apart from middleware settings what else are required .

As per my knowledge, Now i should create a account group in ISU and number range should be assinged to that..After that I should do the mapping process using PIDE settings...but i m not very clear with this process..

can any one give me clear steps to achieve this ?

Thanks & Regards,

Ravi

[Former Member]

hi

[Former Member]

Hi

When the requirements for BP replication will be served by CRM middleware process only, Nothing else is required,

Ya it depends in if you dont require updation from CRM to R3, and only updation needed from R3 to CRM .these are process based scenarios which you can control with Middleware, If You be clear about ur Business process then we could suggest what need to be done apart from standard.

sree

[Former Member]

Hi Ravi

i have same question, how to start initial and delta BP loads from CRM to ISU. Were you able to complete the settings?

If yes, what setting you did in PIDE. I have tried doing PIDE with all combinations of classification and Account group, but still the initial and delta load from CRM to ISU is failing.

The other way around it is fine. That is i am able to do the initial and delta loads from ISU to CRM with the BP master data.

Appreciate your help.

Thanks

Keerthi