Skip to Content
avatar image
Former Member

Process messages

I would want to send the process messages for partial goods issues/ confirmations or goods receipts from a PI sheet. AT present I am able to send the process messages only when I complete the PI sheet. Is there any configuration that I need to do to send process messages before the PI sheet is completed.

Regards

Ram

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    Jul 26, 2008 at 05:21 AM

    Hi Ramanujan,

    Pls do following Changes to your Process Instruction.

    First of all create one Process massgae Characterstic For Example ZPPPI_MATERIAL_ISSUE

    Value type Characterstic.

    Give Two Value 1) Partial 2) Complete

    Now Add following Characterstic In sequence to your Process instruction catagory.(inclue ZPPPI_Material_Issue to your process massage catagory also)

    PPPI_INPUT_Request         Material Issue
    PPPI_Variable                       Y
    PPPI_Requsted_value         ZPPPI_Material_Issue
    PPPI_Commmand              Close Table Row
    PPPI_Action                      Excute
    PPPI_Formula                    Y=Partial

    Now what happen after selecting all other information like Batch , Quantity if user has select value partial for characterstic Zpppi_Material_Issue system complete that table line and generates one process massage PI_CONS.Then send that massage though CO54.Material document will generate for the matrerial issue.

    Now by using add line in pi sheet you can do nember of times partial material issue.

    Regadrs,

    Dhaval

    Edited by: Dhaval Choksi on Jul 26, 2008 10:51 AM

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 25, 2008 at 03:37 PM

    Dear,

    In the Control recipe in process message make it as repeate so that you will get the PI sheet for partial quantities.

    Hope it will help.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Dear,

      Do as below

      Use CONS_1 as a PI cat.

      In CONS_1

      PPPI_DATA_REQUEST_TYPE = Repeated data request.

      Create Process order and release see that CR is created.

      IN CO60, find the PI sheet for the order and click on change

      Enter the material no and qty and click on report data.

      youn will get the entry in PI sheet.

      In CO54 you will get the entry in to be sent push button , click on this and go inside, select the entry and click on send.

      Again in CO60 you can report the addiotional data and repeate the cycle.

      you cann see all the entries inn PI sheet.and material document for the order

      Please follow the steps and tell me where exactly you have the issue.