idoc to jms..

[Former Member]

I am doing idoc to jms...

both the structures are same...i felt i dont need mapping...

if so wha are the steps i should do in IR...

[Former Member · Accepted solution]

upload metadata and in interfaces use it as message type. Later inside integration directory configure it without interface mapping because interfaces willl be based on the same message.

Kind regards,

Wojciech

[Former Member · Accepted solution]

Thaks for ur reply...

i want to know if i need to create receiver JMS DT,MT,MI,MM,MI in IR or ?

how is that...

[former_member181962 · Accepted solution]

YOu do not need to create any of them in IR.

Regards,

Ravi

[Former Member · Accepted solution]

In case having definition of idoc in one SWCV than for jms you need to create just interface nothing else. Only in case when you are holding the idoc definition in different SWCV than you have to define a dependency in SLD and than use the idoc definition from basic component.

/wg

[Former Member · Accepted solution]

no need of data type...can some one guide me..

I have an IDOC at sender...and i am going with same tructure as idoc in the receiver .

so what are the steps please in IR and ID...

any ideas please

Edited by: PSRK on Jul 25, 2008 11:23 AM

[Former Member · Accepted solution]

Hey

In IR,you need to define a Inbound Message interface for JMS.

This interface can use Message type of IDOC itself.

No need of anything else.

In ID do as a usual scenario,you don't need sender communication channel or sender agreement for IDOC.

You need,Receiver determination,Interface determination and receiver agreement

Thanx

Aamir