Skip to Content

BW4HANA BASED TRANSFORMATION AMDP FIELD ROUTINE DEBUGGING NOT WORKING

Hi

We are on a BW4Hana system. SP01.

I'e created a hana based transformation with an AMDP field routine.

When trying to debug. These are the steps I follow.

. I add the breakpoint to my AMDP script

. Run the DTP in extraction mode.

I am expecting to see the pop up box to switch to the debugging perspective where I can step through the code in debug mode.

However, this box does not appear. Only the DTP monitor follows.

This debug process worked for me in 7.5, so I'm not sure if the process has changed or if there is additional config that' needed here?

Please could you advise ?

Thanks

Salwa

Add comment
10|10000 characters needed characters exceeded

  • I have the same issue, I cannot debug in BW4HANA.

    SAP told me to set the breakpoint from the ABAP perspective, by opening the class direclty,

    because opening the class directly opens the active version. However, in that case, the debugger

    doesn't start either.

  • Get RSS Feed

0 Answers